1. Draw or upload your design onto your cutting machine software and input the appropriate settings.

2. Load your vinyl sheet onto the cutting plotter.

3. Cut your your image.

4. Weed your design (if applicable).

5. Lay your vinyl sheet on a flat clean surface.

6. With the design facing up, cut the required number of masking tape strips. Make sure the entire surface of your vinyl sheet is covered.

7. With a brayer roller or a squeegee smooth out the tape to remove air bubbles.

8. Turn the vinyl sheet over, with the backing side up, and smoothen as well.

9. Peel the tape slowly to ensure the entire design is transferred onto the tape.

10. Before transferring  the vinyl, don’t forget to clean the surface on your chosen project.

11. Carefully stick your vinyl on the surface, smoothen and carefully peel the tape backing.

12. Check to see if any of the images is still stuck on the tape.  

Voila! You will see that you can transfer vinyls easily without transfer tape.

Tip: Organize your stuff, including excess vinyl, neatly after each project, this way you can check what other items are still available to use and reuse.